AC Inverters and Controls
2730 Single Pushbutton, E-Stop
Used with our pre-wired control panel on Zig-Zag conveyor applications. The E-Stop Push Button station can be mounted anywhere along the conveyor system allowing operators to halt the conveyor.
Product Details...
Product Details...
2830 3-Pushbutton Station, Start/Stop/E-Stop
The 2830 Three Push Button Station - Start/Stop/E-Stop is designed for use with our pre-wired control panel on Zig-Zag conveyor applications. The Three Push Button Station can be mounted anywhere along the conveyor system so that an operator can Start, S
Product Details...
Product Details...
DR-2700 Conveyor Control Panel
NEMA #12 enclosure (approximately 24" x 24") with door mounted main supply disconnect. Externally mounted start, stop, emergency stop pushbuttons and fwd/rev selector switch.
Product Details...
Product Details...
DR-2798 A C Inverter, 3/4 HP, 208/230V-3
Used on Zig-Zag systems to control the operating speed of the drive unit. Inverter unit rectifies the AC supply voltage to a pulsating DC voltage. DC voltage is converted back to AC voltage with a variable frequency, providing motor RPM conveyor speed con
Product Details...
Product Details...
DR-2799 A C Inverter, 1.5 HP, 208/230V-3
Used on Zig-Zag systems to provide operator speed-control of the drive unit. The A.C. Inverter unit rectifies the AC supply voltage to a pulsating DC voltage. The DC voltage is converted to AC voltage with a variable frequency, which provides motor RPM sp
Product Details...
Product Details...
DR-2800 A C Inverter, 3/4 HP, 460/480V-3
Used on Zig-Zag systems to provide operator speed control of the drive unit.
Product Details...
Product Details...
DR-2802 A C Inverter, 1.5 HP, 460/480V-3
Designed for use on 1-1/2 HP motors with 460/480V -3P power. Can drive the motor speed from a maximum of 1750 rpm (full load speed @ 60 hertz.) down to a minimum of 350 rpm (5:1 speed range).
Product Details...
Product Details...